Amazone AMASPRAY+ - Putting the Machine into Operation; Entering Distance Calibration Values; Setting the Working Width

Putting into operation
AMASPRAY+
BAG0017.7 10.17
19
Determination of impulses per 100m:
1. Accurately measure out in the field a calibration distance of
100m.
2. Mark the start and the finish points (Fig. 4).
Fig. 4
3. Simultaneously actuate the keys
and .
4. Drive down the measure distance of exactly 100m and stop.
5. Confirm the determined value with key
.
Input of impulses per 100m:
1. Actuate key .
→ the actual value is indicated.
2. Enter the value with the keys
or .
3. Confirm with key
.
5.3 Input of working width (pre-set by the factory)
1. Actuate key .
→ the actual value is indicated.
2. Enter the value with the keys
or .
3. Confirm with key
.