Amazone AMASPRAY+ - Putting the Machine into Operation; Parameter 1: Tank Fill Level Setup; Parameters 2-4: Alarm Limit Configuration; Parameter 8: Driving Simulator Settings

Putting into operation
AMASPRAY+
BAG0017.7 10.17
25
Parameter 1 → display
Actual fill level curve is indicated by indication of the tank volume.
Selection 0:
Learnable fill-level curve selected (Record fill-level curve via "Learn
fill-level curve")!
Selection
- - - -:
Level sensor deactivated! For example in event of using an additional
front tank, → add tank content manually, see page 27.
Parameter 2
→
display
Enter alarm limit for residue in tank.
Parameter 3
→
display
Enter alarm limit for minimum spraying pressure.
Parameter 4
→
display
Enter alarm limit for maximum spraying pressure.
Menu items , , only for maintenance / service staff!
Parameter 8 → display
Switch driving simulator on or off.
• Enter simulated forward speed.
• Entry 0.0, driving simulator switched off.
When using the driving simulator, withdraw the connection for the
wheel sensor or the signal socket.
As soon as the AMASPRAY+ receives signals from the wheel sensor
or from the signal socket, the driving simulator is switched off.
Parameter 9 → display
Select transfer rate of serial interface.
Enter 19200 or 57600 baud.