Amazone AmaSpread+ - 4.3.1 Determining; entering the calibration factor; Calibration Factor Input; 4.3.2 Adjusting the limiter; Limiter Settings for Spreading

Settings
AmaSpread+
BAG0126.4 09.17
15
4.3.1 Determining / entering the calibration factor
• Enter the calibration factor
1.00
• Determine the calibration factor
(see page 24)
4.3.2 Adjusting the limiter
Perform the settings for:
1 - Ditch spreading
2 - Boundary spreading
3 - Border spreading
• Limiter position
→ 0 Limiter raised to its maximum position
→ 100 Limiter lowered to its maximum position
20
• Quantity reduction
10 %
• Note
• Spreading disc speed for boundary spread-
ing
720 rpm
4.3.3 Empty hopper
For residual emptying, open the two
shutters and then close them again later.
0.0 km/h
• Display shutter open / closed
• Display shutter in %
100 %
100 %