BAG0126.4 09.17
9.3 Procedure for use
CAUTION
Risk of injury to persons standing beside or behind the imple-
ment due to thrown fertiliser grains.
Observe the throwing distance of the fertiliser spreader when opening
the shutter and instruct persons to exit the danger area.
1. Switch on the AmaSpread
+
.
ο Enter the data according to the setting chart.
ο No weighing spreader: Perform the spread rate check be-
fore starting work.
2. Starting driving the tractor and set the required PTO shaft
speed.
3. Weighing spreader: Perform online calibration, or start calibra-
tion run for offline calibration.
4.
When the switch-on point is reached: Open both
shutters.
5.
At the headland when the switch-off point is reached:
Close both shutters.
→
If necessary, select boundary spreading method with
opened or closed shutters.
6. Offline calibration: Spread at least 200 kg of fertiliser, and then
terminate the calibration run. If possible, perform additional cali-
bration runs with larger quantities of fertiliser.
7. After operation:
Close shutters.
Switch off AMASPREAD+.
• The spread rate is regulated automatically.
• The shutter closes at speeds below 1 km/h.
• The shutter opens at start-up.
To Next Page
Loading...
