Amazone AmaSpread+ - Slug pellets, fine seeds operation; Before Operation (Slug Pellets); During Operation (Slug Pellets); After Use (Slug Pellets)

Operation
34
AmaSpread+ BAG0126.4 09.17
Slug pellets, fine seeds:
Before operation:
1. Select the "Slug pellets, fine seeds" mode (advanced settings
menu).
2. Perform a spread rate check.
3. Enter the intended forward speed as the simulated speed.
During operation:
• Drive at a constant speed, since the speed-proportional rate
control is switched off.
After use:
• Simulated speed = set to 0 (no simulated speed).
A flashing display of the shutter indicates that the setting motor and
AmaSpread
+
are not synchronised.
In this case, close the shutter and open again.