Amazone AmaSpread+ - 11.3 Notes; Error Number Notes

Faults
AmaSpread+
BAG0126.4 09.17
43
11.3 Notes
A notification appears when the operator must react to an error.
Acoustic signal: 3 x tone signal for a duration of 1 second
Error number: 11 Setpoint value cannot be maintained
Error number: 12 Fill level too low
Error number: 13 Spreading disc speed too low
Error number: 14 Value on scales fluctuates
Error number: 15 The required quantity has not yet been spread. Abort calibra-
tion?
Error number: 16 Error in calibration of scales (parameter 2 below 1.0), please
repeat
Error number: 17 Calibration not possible, left-hand shutter open
Error number: 18 Calibration not possible, disc speed cannot be maintained
Error number: 20 This value lies outside the set limits, accept anyway?
Error number: 21 Calibration on the move not possible.
Error number: 22 Calibration not possible due to setpoint, please check calibra-
tion factor and intended forward speed
Error number: 23 You are changing the basic setting of the scales
Error number: 24 Hopper fill level too low, minimum hopper content 200 kg
Error number: 25 Online calibration factor 5x outside realistic values
Error number: 26 Do you want to delete this job?
Error number: 27 Caution, you are changing the basic settings of the implement
Error number: 28 Do you really want to restore all data to the factory settings?
Error number: 30 Calibration factor is outside the realistic limits
Error number: 31 Calibration cancelled
Error number: 33 Do you want to delete this dataset of the settings?
Error number: 34 Do you want to delete this tractor?
Error number: 35 Do you really want to restore all data to the production set-
tings?
Error number: 36 CAUTION, reduction of the tasks leads to data loss?
Error number: 37 CAUTION, observe the instructions in the operating manual
before calibration
Error number: 38 CAUTION, observe the instructions in the operating manual
before diagnosis
Error number: 42 Left hopper is empty
Error number: 43 Right hopper is empty