Amazone FTender 1600 - Page 4

5.11 Chain oil 43
6
Preparing the machine 44
6.1 Calculating the required tractor
characteristics 44
6.2 Coupling the implement 47
6.2.1 Driving the tractor towards the
implement 47
6.2.2 Coupling the power supply 47
6.2.3 Connecting the conveyor line 47
6.2.4 Coupling the pressure gauge 49
6.2.5 Coupling the electric supply lines 49
6.2.6 Coupling the hydraulic hose lines 49
6.2.7 Connecting the camera system 52
6.2.8 Coupling the 3-point mounting frame 52
6.2.9 Removing the rolling and parking
device 52
6.3 Preparing the implement for
operation 53
6.3.1 Adjusting the working position sensor 53
6.3.2 Moving the T-Pack F into working
position 53
6.3.3 Using the hopper cover 55
6.3.4 Using the loading board 57
6.3.5 Using the filling auger to fill the
hopper 57
6.3.6 Filling the hand wash tank 59
6.3.7 Preparing the metering unit for
operation 60
6.3.8 Operating the one-sided switching 69
6.3.9 Adjusting the fan speed 71
6.3.10 Setting up the speed sensor 72
6.3.11 Changing the implement controls 72
6.3.12 Adjusting the low level sensor 74
6.3.13 Installing ballast weights 75
6.3.14 Mounting the T-Pack F 76
6.3.15 Dismounting the T-Pack F 79
6.3.16 Using the parking supports 84
6.4 Preparing the machine for road
travel 85
6.4.1 Move the T-Pack F into parking
position 85
6.4.2 Monitoring cross-traffic 86
6.4.3 Switching off the work lights 87
7
Using the machine 88
7.1 Using the implement 88
7.2 Using a hydraulically actuated
working position sensor 88
7.3 Turning on the headlands 89
8 Eliminating faults 90
9 Parking the machine 91
9.1 Emptying the hopper 91
9.1.1 Emptying the hopper via the quick
emptying 91
9.1.2 Emptying the hopper via the
metering unit 91
9.2 Emptying the metering unit 95
9.3 Emptying the filling auger 97
9.4 Installing the rolling and parking
device 99
9.5 Uncoupling the 3-point mounting
frame 100
9.6 Driving the tractor away from the
implement 100
9.7 Disconnecting the hydraulic
hose lines 101
9.8 Uncoupling the power supply 101
9.9 Uncoupling the pressure gauge 102
9.10 Uncoupling the conveyor line 102
10
Repairing the machine 103
10.1 Maintaining the machine 103
10.1.1 Maintenance schedule 103
10.1.2 Checking the lower link pins and
top link pins 104
10.1.3 Checking the hydraulic hose lines 105
10.1.4 Cleaning the conveyor section 105
10.1.5 Cleaning the suction guard screen 107
10.1.6 Cleaning the cyclone separator 107
10.1.7 Cleaning the hopper 108
10.1.8 Cleaning the metering unit 109
TABLE OF CONTENTS
MG6492-EN-II | P.1 | 21.11.2023 | © AMAZONE
II