displayed. Once the signal is reacquired, the remote
search icon will turn off, and the current values
will be displayed.
The maximum line of sight communication range is 300
feet and 100 feet under most conditions. Move the sensor
assembly closer to the display console.
If the sensor assembly is too close (less than 5’), move
the sensor assembly away from the display console.
Make sure the remote sensor LCD display is working
and the transmitter light is flashing once per 60 seconds.
Install a fresh set of batteries in the remote
thermo-hygrometer. For cold weather environments,
install lithium batteries.
Make sure the remote sensors are not transmitting
through solid metal (acts as an RF shield), or earth
barrier (down a hill).
Move the display console around electrical noise
generating devices, such as computers, TVs and other
wireless transmitters or receivers.
Move the remote sensor to a higher location. Move the
remote sensor to a closer location.
Make sure the thermo-hygrometer is mounted in a
shaded area. The pre preferred location is a north facing
wall because it is in the shade most of the day.
Consider the following radiation shield if this is not
possible:
http://www.ambientweather.com/amwesrpatean.html
Allow up to one hour for the sensors to stabilize due to
signal filtering. The indoor and outdoor temperature
sensors should agree within 2 °F (the sensor accuracy is
± 1 °F).
Use the calibration feature to match the indoor and
outdoor temperature to a known source.
To Next Page
Loading...
Need help?
General
