Version 1.1 ©Copyright 2016, Ambient LLC. All Rights Reserved. Page 37
signal filtering. The indoor and outdoor humidity sensors
should agree within 10 % (the sensor accuracy is ± 5 %).
Use the calibration feature to match the indoor and
outdoor humidity to a known source.
Display console contrast is weak
Replace console batteries with a fresh set of batteries.
Outdoor color does not change as
expected.
Make sure the outdoor sensor is assigned to Channel 1.
13 Maintenance
Clean the rain gauge once every 3 months. Pull out the Rain Gauge Filter drawer, as shown in
Figure 16.
Replace the wind, rain and thermo-hygrometer transmitter batteries once every 1-2 years
Clean the anemometer solar panel once every 3 months.
14 Accessories
The following software and hardware accessories are available for this weather station at
www.AmbientWeather.com .
Energizer AAA Lithium
Battery (2-pack) - Batteries
for Long Life and Cold
Climates
AAA lithium batteries for cold weather climates.
Energizer AA Lithium
Battery (2-pack) - Batteries
for Long Life and Cold
Climates
AA lithium batteries for cold weather climates.
Ambient Weather
SRS100LX Temperature
and Humidity Solar
Radiation Shield
Solar Radiation Shield improves temperature accuracy for hot weather
climates. Install over thermo-hygrometer.
Ambient Weather Humidity
Calibration Kits
One step calibration kits for digital hygrometers use salt slurry formula
to accurately calibrate the indoor and outdoor hygrometers.
15 Liability Disclaimer
Please help in the preservation of the environment and return used batteries to an authorized depot.
The electrical and electronic wastes contain hazardous substances. Disposal of electronic waste in
To Next Page
Loading...
Need help?
General
