Figure 1
4.2 Recommend Tools
Phillips Precision screwdriver Size: PH0 and PH2
Compass or GPS (for wind direction calibration)
Adjustable Wrench
Hammer and nail for hanging remote thermo-hygrometer transmitter.
4.3 Anemometer Assembly Sensor Set Up
The anemometer assembly consists of the wind cups, wind vane, solar panel, bubble level, sensor
mounting bracket and mounting foot. The solar panel provides power to the anemometer when the
sun is out, and the batteries provide power at night (the solar panel does not charge the batteries).
Figure 2
To Next Page
Loading...
Need help?
General
