Version 1.1 ©Copyright 2016, Ambient LLC. All Rights Reserved. Page 12
4.6.2 Display Console Set Up
Note: Power up the rain gauge, anemometer and thermos-hygrometer sensors first before
powering up the console. If you power up the console first, you will need to resynchronize the
sensors.
Make certain the weather station sensors are at least 10’away from the console and within
100’of the console. If the weather station is too close or two far away, it may not receive a proper
signal. If you have more than one thermo-hygrometer transmitter, make sure they are all powered
up and transmitting on different channels.
1. Remove the battery door on the back of the console, as shown in Figure 12.
2. Insert four AA batteries in the back of the display console. The display will beep once and all of
the LCD segments will light up for a few seconds to verify all segments are operating properly.
The console will cycle through a spectrum of colors.
Note: The character contrast is best viewed from a slightly elevated angle.
Figure 12
3. Replace the battery door, and fold out the desk stand and place the console in the upright
position.
The console will instantly display indoor temperature, humidity, pressure, tendency, moon
phase and time. The wind speed, wind gust, wind direction, rain, outdoor temperature and
humidity will update on the display within a few minutes. Do not Press any menu buttons
until the outside transmitter reports in, otherwise the outdoor sensor search mode will be
terminated. When the outdoor transmitter data has been received, the console will
automatically switch to the normal mode from which all further settings can be performed.
To Next Page
Loading...
Need help?
General
