Version 1.1 ©Copyright 2016, Ambient LLC. All Rights Reserved. Page 9
Figure 9
Channel Number: The WS-11 supports up to eight transmitters. To set each channel number
(the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in Table 1.
Temperature Units of Measure: To change the transmitter display units of measure (°F
vs. °C), change Dip Switch 4, as referenced in Table 1.
Table 1
2. Insert two AAA batteries.
3. After inserting the batteries, the remote sensor LED indicator will light for 4 seconds, and
then flash once per 60 seconds thereafter. Each time it flashes, the sensor is transmitting
data.
4. Verify the correct channel number (CH) and temperature units of measure (°F vs. °C) are
on the display, as shown in Figure 10.