PN 305725901, Rev YF
Unpacking and Inspecting the Equipment
Remove any packing material from the 3050-DO Analyzer. Check for damage. If
equipment is damaged, notify the carrier and contact AMETEK Service (https://
www.ametekpi.com/customersupport/requestsupport) immediately if parts
are missing or damage is found, and to verify if damaged parts will require
replacement prior to safely installing and operating the analyzer/equipment.
Tools, Equipment, and Supplies Required for
Installation
To install the analyzer you need the following tools, equipment, and supplies:
• Set of open-end wrenches for ttings.
• Set of metric hexagonal wrenches.
• Set of ball drivers.
• Wire cutters, strippers, and crimpers.
• Flat blade instrument screwdriver.
• Soft, nonabrasive cloth.
• Wrist strap (for grounding).
• Detergent-based leak detector (Snoop® or another suitable leak detection
agent is permissible).
2-4 | 3050-DO Moisture Analyzer
To Next Page
Loading...
