Ametek 3050-DO

Weekly Select Weekly to enable a weekly Zero calibra-
tion. Then, select a day from the Day of the
week drop-down list, and enter the time of
day (1 through 24) in the Hour eld, to indicate
when the Zero calibration will begin.
Monthly Select Monthly to enable a monthly Zero
calibration. Then, enter the day of the month
(1through 28) in the Day eld, and the time of
day (1 through 24) in the Hour eld, to indicate
when the Zero calibration will begin.
Saving the Settings on the Verication Tab
To save settings on the Verication tab, click Apply.
To discard the changes you have made, click Cancel. This will close the 3050
Congurator Software program.
PN 305725901, Rev YF
Controller/Interface | 3-17