Ametek 3050-DO

PN 305725901, Rev YF
Conguring the 3050-DO Analyzer
This section provides instructions for setting up your operating parameters us-
ing the Congurator Software.
Working From the General Tab
Use the General tab to view the current conguration and dene parameters
for the analyzer and to congure the PC Communications (Figure 3-1). With
Version 2.0 and later, you must click the Setup button and accept the changes
before communications begin.
After communication with the analyzer has been established, any
changes to the analyzer communications parameters must be made
from the Device Communication tab. These changes must be made
before you make any changes to the computer serial port settings.
Figure 3-1.
General tab.
3-2 | 3050-DO Moisture Analyzer