Ametek 3050-DO - Page 28

83 pages

To Next Page

To Previous Page

PN 305725901, Rev YF

Figure 2-4.2.

Optional Heated Pressure

Reducer installation.

2-10 | 3050-DO Moisture Analyzer

Main Page

Table of Contents3
Safety Notes6
Electrical Safety6
Grounding6
Personnel and Equipment Safety Information7
Important Notice to Users9
Electromagnetic Compatibility (EMC)10
Warning Labels11
Environmental Information - WEEE11
Overview13
Controller Communication15
Verification15
Gas Flow16
Internal Timing16
3050-DO Analyzer Gas List18
Installation and Start-Up19
Safety Considerations19
Pre-Installation Requirements20
Personnel Technical Level Required for Installation20
Storage Prior to Installation20
Analyzer Site Preparation20
Unpacking and Inspecting the Equipment22
Tools, Equipment, and Supplies Required for Installation22
Mechanical Installation24
Optional Heated Pressure Reducer Installation27
Electrical Connections in the Customer Connection Junction Box29
20 Ma Output Wiring31
RS485 Cables, Multiple 3050-DO Analyzers33
RS485 to RS232 Conversion for Host PC34
Analyzer Start-Up35
Dry down Period35
Status Leds and Alarms35
Configuring the 3050-DO Analyzer for Remote Verification36
Controller/Interface37
AMETEK 3050 Analyzer Configurator Software37
Installing the Configurator Software37
Configuring the 3050-DO Analyzer38
Working from the General Tab38
Saving the Settings on the General Tab40
PC Communications Setup Options41
AMETEK Serial Communication Setup42
Modbus Serial Communication Setup43
Modbus TCP Communication Setup44
Saving the PC Communication Settings44
Working from the Device Communications Tab45
Configuring Multiple Analyzers45
Changing Communication Parameters45
Saving the Settings on the Device Communication Tab47
PC Communications47
Working from the Setup Tab48
Saving the Settings on the Setup Tab49
Working from the Verification Tab50
Saving the Settings on the Verification Tab53
Viewing Live Data from the Status Tab54
Working from the Monitor Tab55
Maintenance and Troubleshooting59
Aftermarket Excellence and Long-Term Commitment to Safety and Quality60
Requesting Technical Support61
Requesting Authorization to Return Equipment61
Requesting Analyzer Training61
3050-DO Analyzer Replacement Parts62
Alarm and Warning Messages63
Specifications65
3050-DO Moisture Analyzer Specifications65
3050-DO Moisture Analyzer Approvals and Certifications66
3050-DO Moisture Analyzer Marking66
Serial Communication Interface (Modbus)67
Analyzer Modbus Interface Parameters69
Modbus Address69
Communication Parameters69
Modbus Functions70
Exception Code70
Holding Registers71
ID/Status Information77
Analyzer Configuration Operations78
Configuration Examples78
Example 1: Alarm Enable78
Example 2: Setting the High Alarm Limit78
Example 3: Setting the Low Alarm Limit79
Example 4: Enabling "Hold During Verify79
Example 5: Setting the High End of the Analog Output79
Example 6: Setting the Low End of the Analog Output79
Example 7: Switching to "Sensor Saver" Mode79
Example 8: Switch to Dewpoint Readings80
Example 9: Selecting a Sample Gas81
Example 10: Setting Verification Schedule82

Ametek 3050-DO - Page 28

Table of Contents

Related product manuals