Ametek AMP 200N - Software Setup: Voltage and Current Monitoring

AMETEK CTS AMP 200N series
Manual for Operation V 4.0.3 53 / 60
Software setup
Setup with voltage and current inputs used in the normal way.
Voltage Monitor
In this case the internal AMP 200N voltage measuring
input is used (4mm lab connector input).
PVS 7 as differential voltage probe with 1000:1 ratio
Current Monitor
In this case the internal AMP 200N current measuring
input is used (BNC connector input).
Keysight N2783B as active current probe