To Next Page

To Previous Page

Because ultraviolet radiation can harm your eyes, never look directly into the operating lamp.

If the Xenon Flash Lamp must be viewed while energized, wear safety glasses that block ultra-

violet radiation.

If the Oven/Sample System Enclosure is heated, the components within it will be hot; take

precautions to avoid burning yourself.

Explosion Hazard – Do Not enter purge BYPASS mode in the presence of explosive atmo-

sphere.

Verify ground continuity of all equipment before applying power.

The sample gas may contain highly toxic and corrosive substances. Proper personal protective

equipment including fresh air breathing apparatus, eye protection, and skin protection MUST

BE worn when installing the sample tap and/or opening the main oven chamber for inspection

or maintenance.

If sampe gases contain highly toxic and corrosive compounds, analyzed sample must be re-

turned to the process or vented to a safe area.

Cautions

Review and follow these Cautions to avoid damaging the equipment.

The electronic circuit boards and other static-sensitive components should be stored and trans-

ported in static-shielding carriers or packages.

For electrical-shock protection, the analyzer must be operated from a grounded power source

that has a securely connected protective-ground contact.

If it becomes necessary to handle any of the electronic circuit boards, do not subject the boards

to static discharge. The ideal solution is a static-safe work area. Since such areas typically

are not available at analyzer installation sites, the use of a wrist strap connected directly to a

ground is recommended. If a wrist strap is not available, you should at the very least touch the

metal chassis (to ground yourself) before handling or touching the boards.

WARNING

CAUTION

Essential Health & Safety Requirements | 7

Ametek IPS-4 Essential Health & Safety Requirements

Other manuals for Ametek IPS-4