18 | IPS-4 Zone1/Analyzer
Safety Considerations
Before beginning the installation of the analyzer and before powering
it up, review and follow all safety requirements under “Important
Safety Notes, Warnings, and Cautions” following the Table of Con-
tents near the beginning of this manual. This information describes
procedures to follow to avoid personal injury and/or damage to the
equipment. All regulatory agency and personnel safety procedures
for your jurisdiction must be followed.
The IPS-4 Analyzer is certified with regard to electrical safety for
Pollution Degree 2 (normally nonconductive environmental pollution
occurs with occasional condensation) and Installation Category II (lo-
cal level transients, less than those found at power distribution level).
Mains supply voltage fluctuations are not to exceed 10 percent of the
nominal supply voltage.
NOTE
!
WARNING
To Next Page
Loading...
Need help?
General
