Ametek JOFRA ATC-156 B - Resetting the Calibrator Setup to Factory Defaults

60 23-03-2009 105446 06
F3F2 F4 F5F1
The following features can be protected by an access code:
 Resetting the calibrator to Factory default settings.
 Setting the Maximum SET Temperature.
 Editing the Access code while it is enabled.

Press
to change the Access code.

Use the numeric keys to type in a value from 0000 to 9999.
Typing 0000 disables the access code function.

Press
to accept the new access code and exit the editor
by pressing
again
.
4.8.9 Resetting the calibrator setup to factory defaults
Resetting to the factory default settings changes the setup to
the initial settings.

Press
(setup page 3) to restore Factory defaults (ATC-
125/156/157/320/650 A/B).

Press
(setup page 3) to restore Factory defaults (ATC-
140/250 A/B).
Caution…
By pressing
(Yes) the following will be deleted :
 Work orders
 Setup parameters
 Autostep results
 Switch test results