68 23-03-2009 105446 06
If the fuses blow immediately after you have replaced them,
the calibrator should be returned to the manufacturer for
service.
6.1 Returning the calibrator for service
When returning the calibrator to the manufacturer for service, please
enclose a fully completed service information form. Simply copy the
form on the following page and fill in the required information.
The calibrator should be returned in the original packing.
The ATC-125 contains the flammable refrigerating gas R-1270 and the
gas R-704. The amount of gas is less than 100g and it is considered
not subject to the Dangerous Goods Regulations. However this must
be declared when shipping.
When sending the ATC-125 please mark the package and the shipping
papers with this text:
* NOT RESTRICTED , SPECIAL PROVISION A103 *
Note…
If the software detects an error during operation, the error
will be shown in the display.
Make a note of the error message and contact your
distributor or AMETEK Denmark’s service department.
AMETEK Denmark’s liability ceases if:
parts are replaced/repaired using spare parts which are
not identical to those recommended by the manufacturer.
non-original parts are used in any way when operating
the instrument.
AMETEK Denmark’s liability is restricted to errors that
originated from the factory.
To Next Page
Loading...
