Ametek MiniFlash FP Vision User Manual

Name: Ametek MiniFlash FP Vision
Brand: Ametek
Rating: 4 (1 reviews)

69 pages

To Next Page

To Previous Page

Measurement cycles: here the number of continuous measurements can be entered.

NOTE: every measurement cycle is completed with the amount of cycles entered.

Ti is the initial temperature starting point for the measurement cycle.

According to ASTM standard D6450 and D7094, the start temperature must be 18 °C (64,4 °F) below the expected

flashpoint.

Questions and Answers:

Need help?

Do you have a question about the Ametek MiniFlash FP Vision and is the answer not in the manual?

General