Ametek Reichert 7CR User Manual

16060-101 Rev. M
28
Alignment & Measurement
Measuring the Next Eye
There are several options available at this point:
a. The Forehead Rest may be slid to the opposite side to continue taking measurements on the
other eye.
b. 

c. The data can be printed by touching the PRINT icon.
Note: The instrument will print out the data from both eyes if the PRINT icon is touched after both
eyes are measured.
Note: Measurement data should always be printed or cleared after a patient is completed. Leaving
readings on the screen can result in “mixing” of data when the next patient is measured.


Ametek Reichert 7CR Specifications

General

Tonometer Type	Non-contact
IOP Measurement Range	7 to 60 mmHg
Working Distance	11 mm
Accuracy	±1 mmHg
Resolution	1 mmHg
Power Supply	100-240V AC, 50/60 Hz
Housing Material	Plastic
Protection Rating	IP20
Output	RS-232