16060-101 Rev. M
9
Application of Input Power
WARNING:
WARNING: POSITION THIS INSTRUMENT SO THAT IT IS NOT DIFFICULT TO OPERATE THE DISCONNECTION
1. After the unit is in its secure location, apply the correct input voltage to the instrument using the
Power Cord from the Accessory Tray.
2. Press down on the “|” located on the ON/OFF Switch. The power inlet is located on the
3. Read the User’s Guide and the Quick Reference Card before operating this instrument.
WARNING:
CAUTION:
OCCUR.
CAUTION:
THIS MANUAL.
Disconnection of Input Power
1. At any time, the power switch can be set to OFF. The unit does not have a power down sequence.
2. If this instrument is intended to be OFF for an extended period of time, it can be disconnected from
power by detaching the power cord from the its receptacle.