16060-101 Rev. M
33
Fuses
WARNING:
Replace the fuses in the Power Input Module with the fuses indicated in the Specifications section of
this manual.
1. Remove input power to the instrument.
2. Press down on the tab in the middle of the Power Input
Module to release the Fuse Holder. Refer to item 1.
3. Pull the fuse holder out of the input module.
Refer to item 2.
4. Install new fuses that are indicated in the Specification
section of this manual into the Fuse Holder.
5. Push the Fuse Holder into the Power Input Module until
it snaps into place.
External Cleaning
Clean the external surfaces of this instrument using a clean, soft cloth moistened with a mild detergent
Forehead Rest Cleaning
For hygienic reasons, the Forehead Rest may be cleaned with a clean cloth moistened with a mild
Note: If the Forehead Rest Pad must be sanitized, a sterile wipe may be used occasionally.
Note: Replacement Forehead Rest Pads can be purchased through your local authorized Reichert
dealer under P/N 16050-170.
Operator Display Cleaning
Use a clean, soft cloth with neutral detergent or
ethanol to clean the operator display. Do not use any
chemical solvent, acidic, or alkali solution.
Printer Paper
To change the printer paper, remove the printer
paper door to expose the printer paper compartment.
Remove the cardboard roll and place a new roll of
thermal printer inside the printer paper compartment
as shown below. To order replacement thermal paper,
call your local dealer and ask for Reichert replacement
paper.
Fuse Location
1
2
Fuses
Printer Paper Replacement
To Next Page
Loading...
