Instrument Setup (continued)
Connect External Devices with Reichert Wireless Serial Adapters (continued)
11. On the Port Settings panel tap the Pair button.
12. The LED indicator on the Bluetooth dongle will rst blink about once every second. Once the
connection has been established, the LED indicator will remain on constantly.
Note If the connection was successfully paired, the word “Connected” will be shown in the upper
right corner of the panel. If “Failed” appears, then refer to the previous steps starting with
providing power to the Bluetooth.
13. Remove power from the Bluetooth dongle and disconnect it from the Central Unit.
14. Connect the Bluetooth dongle to the external device’s serial port and then provide power using
the required adapter or cable.
15. The LED indicator on the Bluetooth dongle will rst blink at a rate of once per 0.6 seconds. Once
the connection has been established again, the LED indicator will remain on constantly.
Note: At this point the Central Unit and/or the Bluetooth dongle may be powered off and on in
any order. The wireless connection will be established automatically once both devices are
powered on.
CAUTION: DO NOT TOUCH THE PAIR BUTTON AGAIN. IF THE PAIR BUTTON IS ACTIVATED,
IT WILL BE NECESSARY TO REPEAT THE ABOVE PROCEDURE TO RE-ESTABLISH
THE WIRELESS CONNECTION.
Figure IS-14, Port Settings Screen
21
16241-101 Rev. D
To Next Page
Loading...