Programs (continued)
Running a Program
In the main screen, the programs you created display in the Run Program panel in the lower right corner
of the screen. (Please refer to Figure IS-28.) To run a program:
1. Touch the program number you want to run at the bottom right corner of the screen.
Note: The rst step of the program automatically begins.
2. Press the CONTROL KNOB to advance to the next step after completing a step in the refraction
program.
3. Touch the double yellow bar icon located at the bottom right of the screen to pause the program.
This changes the icon to a green triangle. Touch the green triangle icon to restart the program.
4. Touch the red square icon to stop the program.
Instrument Setup (continued)
Pause
Program
Program
Step
Displayed
Stop
Program
Figure IS-28, Run Program Screen
43
16241-101 Rev. D
To Next Page
Loading...