Ametek Reichert Phoroptor VRx - Connect Acuity Systems to the Phoroptor Vrx

Instrument Setup (continued)
Connect ClearChart
®
2 or ClearChart
®
3 Series to the Phoroptor VRx
Auto Projector Systems are directly connected to the Projector port on the Central Unit using a cable or
a wireless Bluetooth dongle, according to the cables specied in Appendix A.
Wired communication between the ClearChart 2 or ClearChart 3P and the Phoroptor VRx requires
connection of a cable, according to the cables specied in Appendix A. The cable connects to the serial
port on the ClearChart and the Projector port on the Central Unit.
Wireless communication between the ClearChart 2 or ClearChart 3P and the Phoroptor VRx requires
connection of the Bluetooth serial adapter to the serial port on the bottom of the ClearChart 2 or
ClearChart 3P, powered by the USB connection on the side of the device or with a separate AC adapter.
(Please refer to Figure IS-15.)
The Phoroptor VRx Central Unit communicates through built-in Bluetooth using the antenna at the back
of the unit. (Please refer to Figure IS-16.) (Please refer to the instructions in the previous section,
Connecting Auxiliary Equipment with Reichert Wireless Serial Adapters, to connect devices to the
Phoroptor VRx using Bluetooth dongle serial adapters.)
Figure IS-15, ClearChart Bluetooth Dongle Mount
Antenna for
Bluetooth
Figure IS-16, Antenna for Bluetooth - Central Unit
PHOROPTOR
INSTRUMENT 1
PROJECTOR
EMR
INSTRUMENT 2
PRINTER
TRANSFER
CONTROLLER
24 16241-101 Rev. D