Data Input (continued)
Entering Data Manually (continued)
4. Turn the CONTROL KNOB to enter the values for the data elds (Sphere, Cylinder, Axis, Add
etc.).
5. Press the CONTROL KNOB to move to the next data eld.
6. Touch LOCK, after entering all the data for the left and right eyes to save the Auto Refractor
data.
7. Repeat the above steps to enter lensmeter data.
8. Turn the CONTROL KNOB to begin changing Subjective data. The main measurement area
title automatically changes to Subjective.
Note: If you want to delete any of the data entered manually, touch the data field you want to
delete and touch or press CLEAR.
Inputting Data Electronically
The Phoroptor VRx allows you to automatically enter data electronically from auxiliary external devices,
such as Lensmeters and Auto Refractors. Electronically entering data into the Phoroptor VRx is
possible, using one of the following options:
• Direct Connection - The external device sends data directly to the Phoroptor VRx and populates
the AR and LM data elds since the device is directly connected to the Phoroptor VRx, using a
serial cable or Bluetooth adapter.
• Direct Connection to a Stored Data List - The external device data is sent directly to the
Phoroptor VRx and the data are stored in a Data List.
• Through EMR - If the EMR system interfacing with the Phoroptor VRx supports two-way
communication, the external device sends data directly to the EMR system, and then the EMR
system sends the data to the Phoroptor VRx.
Instructions for Use (continued)
57
16241-101 Rev. D
To Next Page
Loading...