Options/Setup Menu (continued)
Binocular Only
This option allows you to leaves both eye apertures open during all far vision tests when selected to ON.
Figure IS-24A, Settings Menu - CC Button
CC Button
Option to choose either the final refraction data or the imported REF data on the display. Refer to Figure
IS-24A.
XCyl Auto
XCyl Auto is either on or off. If XCYL Auto is on, the XCyl Mode selected below automatically begins
when Cylinder or Axis is selected on the Main Screen or Keypad.
XCyl Mode
The XCyl Mode setting specifies the type of XCyl test that automatically starts when an XCyl test is
entered. There are four modes from which to choose: User Select, Manual, Smart, and Split Cyl
modes. User Select Mode brings up a button bar that allows the operator to manually select the Cross
Cylinder test type for the specific patient.
XCyl Equal Keypad Button
XCyl Equal button enables the user to select which button is used during the Manual or Smart Cross
Cylinder test to save the values when the patient sees two images as equal. The options are:
• ENTER button - When you choose the ENTER button option, press the CONTROL KNOB to
select the patient’s preferred image (better 1, better 2), and then press the ENTER button when
the patient sees the images as equally blurry.
• CONTROL KNOB - When you choose the CONTROL KNOB option, press the ENTER button
to select the patient’s preferred image (better 1, better 2), and then press the CONTROL KNOB
when the patient sees the images as equally blurry.
Instrument Setup (continued)
35
16241-101 Rev. D
To Next Page
Loading...