Programs
You can record refraction step sequences in a program le that is selected and run from the main
screen. (Please refer to Figure IS-25.)
Creating a Program
1. Touch the NUMBER in the Program Selection panel to designate the program you want to setup.
2. Touch the step or test you want to add to your program in the Mode panel.
3. Touch the EYE upon which you want to run the test in the Eye panel. (R = right, L = left, B =
both)
4. Touch INSERT in the menu bar at the bottom of the screen. Each refraction step or test appears
in the Program Listing panel.
5. Repeat the above process to add tests or steps to your program.
6. Touch SAVE to save any changes made to programs.
7. Touch EXIT to return to the main screen.
Note: You can store a maximum of 4 programs on the device.
Figure IS-25, Program Screen
Instrument Setup (continued)
39
16241-101 Rev. D
To Next Page
Loading...