Ampler – Stellar / Stout 20Assembly
5 Assembly
The Pedelec is delivered mostly pre-assembled. Some components still need to be attached and adjusted after unpacking.
Assembly
A video for this is available on the Ampler Support Portal. The video explains the necessary assembly steps
in detail and contains further tips.
Attach the charger for the rst start-up
The charger must be attached to wake the bike up from its shipping state and to enable the rst start-up.
Tools required
y 4 mm hex key (included in delivery)
y 6 mm hex key (included in delivery)
Using a torque wrench
If applicable, a torque wrench can be used for assembly (not included; available from specialist shops).
Tightening torques
Screws Tightening torque Explanation
Stem clamping screws max. 6 Nm
The cap screw is correctly tightened when the steering bearing
and the handlebar have no "play" (i.e. do not "wobble" or
"judder") and the handlebar can be moved easily in both
steering directions
.
Headset cap screw max. 2 Nm
Pedals 35 Nm In order to securely attach the pedals, tighten them with
proper strength or use a torque wrench for installation.
To Next Page
Loading...
