Ampler Stellar - Charging the battery with the charger

Ampler – Stellar / Stout 30Before the first ride
Switch light on / switch light o
Pedelec is switched on.
The display shows the active state.
1. Press and hold the power button.
y The display shows the lights icon for approx. 2 seconds
2. Release the power button while the icon is displayed.
y The lights switched on
Repeat the process to switch the lights o.
1. Press and hold the power button for 1 second.
y The display shows the lights o icon for approx. 2 seconds
2. Release the power button while the icon is displayed.
y The lights switches o
If you want to ride with lights on but without motor support then turn the lights on and select 0% assist mode.
6.3.4 Charging the battery with the charger
The factory charge level of the battery is between 40% and 90%.
It is best advised to store the charger indoors.

Read and follow the safety instructions for the battery and the charger.
Before recharging
After a ride in the cold, give the Pedelec some time to acclimatise ("warm up") before charging the battery.

Use the charger indoors only.

Ensure that the charging port on the Pedelec and the charging plug and mains plug of the charger are clean, dry and free from
metallic objects and debris.

The charging process must be carried out in a dry and not too cold environment, but always at least above 0 °C.
Charging the battery
1. Allow the Pedelec and charger to acclimatise to the ambient temperature, if necessary.
2. Lift the charging port cover and insert the magnetic charger plug into the charging socket on the left side of the seat tube.
3. Insert the mains plug of the charger into the mains socket.
y The display shows active charging
1. Current state of charge
2. Remaining charging time until 100%
y The charger charges the battery, the charger LED is red. The time from empty to fully charged takes approx. 2.5 hours.
y The charger stops charging automatically when the battery is fully charged.
y As soon as the display shows 100% and the charger LED is green, the battery is fully charged.
4. Unplug the charger from the mains socket.
5. Unplug the magnetic charger plug from the charging socket on the left side of the seat tube and close the charging port cover.