Ampler – Stellar / Stout 36
8.2.4 Chain
Switch o the Pedelec.
Check the chain wear
The links of the chain may stretch a little over time. Any bicycle workshop can check the chain wear and elongation.
The measurement can also be carried out by yourself with a commercially available chain tester.
J Check the chain wear and elongation
Check the chain lubrication
The chain will run dry over time and lose its lubrication, causing higher friction and wear.
J Clean the chain with a dry cloth
J Oil the chain with a suitable lubricant
J Turn the crank backwards a couple of times to distribute the lubricant evenly
J Evoid to get oil and lubricants in contact with any brake components
J Check the chain for lubrication
Replacing the chain
The chain can be replaced if it’s worn out or damaged. Changing the chain may require special tools which are available at bicycle
dealers. Pay attention to replace the chain with the same specications as the original part.
J Follow the specications and instructions of the manufacturer when replacing the chain.
8.2.5 Wheels
Switch o the Pedelec.
Checking the wheels
J Check wheel alignment and true.
J Replace a damaged wheel in consultation with Ampler Customer Service, or have it replaced in a bicycle workshop in accordance
with Ampler Customer Service instructions.
Check spokes
J Check the wheel spokes.
J If the spokes of the wheels are damaged or loose, only have them trued or replaced by Ampler Customer Service or by
a bicycle workshop.
Check the thru-axle of the front wheel
J Check the thru-axle of the front wheel.
J Tighten the thru-axle. Pay attention to the specied tightening torque.
Check the axle of the rear wheel
J Check the nuts of the rear wheel axle.
J Tighten the nuts. Pay attention to the tightening torque and the instructions for correct tightening.
y When using a torque wrench: Follow the manufacturer's instructions.
Cleaning, maintenance and care
To Next Page
Loading...
