Ampler Stellar - Selecting the assist mode; Switching the lights on and off

29 Before the first ride Ampler – Stellar / Stout
6.3.2 Selecting the assist mode
DANGER
Trying to press the power button while riding can cause an impairment of balance
 Stop the ride to operate the power button.
Falls and crashes can occur when concentrating too much on the display operations while riding.
 Keep the focus on the road ahead and your surroundings while riding.
The electric drive has two assist modes and a 0% assist mode:
y Standard mode - 70% pedalling assistance
y Max mode - 100% pedalling assistance
y 0% assist mode - motor is o, lights can be turned on or o separately
The assist mode is selected before starting the trip when the Pedelec is switched on. The system remembers the last selected mode.
Selecting assist mode
Pedelec is switched on.
If the display is o then it can be “woken up” by a short press on the power button. We recommend not to do this while riding.
The display shows the active state.
1. Shortly press the power button to cycle between modes.
2. The display shows the following icons:
y for standard mode
y for max mode
y for 0% assistance mode
3. Select the desired mode. The icon will be shown for approx. 2 seconds and the mode is set.
6.3.3 Switching the lights on and o
DANGER
Trying to press the power button while riding can cause an impairment of balance
 Stop the ride to operate the power button.
Falls and crashes can occur when concentrating too much on the display operations while riding.
 Keep the focus on the road ahead and your surroundings while riding.
The lights (front light and rear light) are powered by the battery. The front and rear lights are switched on and o together.
The Pedelec always remembers the last selected setting (lights on or o).