Ampler Stellar - Page 28

Ampler – Stellar / Stout 28Before the first ride
Riding the Pedelec
Pedelec is switched on.
As soon as the crank is turned the motor starts to assist the pedaling depending on the selected mode.
The display automatically switches o while riding (screen goes o).
y The display can be lit up by a short press on the power button. We recommend not to do this while riding.
y When the Pedelec is moving slowly or standing still for a short while, the display shows the active trip statistics
1. Distance ridden since last switch-o
2. Trip duration
3. Average speed
y The display then shows the active state.
The Pedelec only records odometer data when it is switched on.
Switching o the Pedelec (automatic switch-o)
After about 2.5 minutes of being idle (Pedelec is standing still and the power button was not pressed) the Pedelec automatically
switches o.
The Pedelec enters standby mode after 3 hours of being idle.
Switching o the Pedelec (manual switch-o)
Pedelec is switched on.
1. Press the power button and hold it.
y The display shows the power o symbol.
2. Release the power button.
y The display switches o.
y The Pedelec switches o.
When the Pedelec is switched o the active trip will stop recording and a trip summary is shown before the display turns o.
1. Trip duration
2. Trip distance
3. Average speed
The trip statistics are automatically uploaded once GSM is active. You can nd the trip history in the Ampler Bike App.