Ampler – Stellar / Stout 42Ampler Bike App
10.2 Install and use the Ampler Bike App on a smartphone
Find more information on installing and registering in the Ampler Bike App.
10.3 Updating the Pedelec's rmware
The Pedelec has a software-controlled motor driver integrated into a control unit. The software of the controller is called rmware
and is updated occasionally.
y We recommend that you always keep your Pedelec's rmware up to date.
All information on how to use the Ampler Bike App to update the Pedelec's rmware is available in
the Ampler Bike App.
10.4 Carrying out a calibration of the torque sensor
During calibration, the Pedelec's torque sensor is calibrated and the functionality of all electronic components is synchronised
with each other. This calibration is carried out using the Ampler Bike App.
We recommend calibrating the sensor every 3 to 6 months.
Ampler Bike App installed on a smartphone.
Ampler Bike App connects to the Pedelec via Bluetooth.
1. In the Ampler Bike App, open the settings menu and select the menu item "System maintenance".
2. Follow the calibration instructions in the Ampler Bike App.
10.5 Carrying out a factory calibration
A factory calibration can only be performed after the Ampler Customer Service enables the possibility through
the Ampler Bike App remotely.
2 When instructed by Ampler Customer Service, open the settings menu in the Ampler Bike App and select the menu item
"Factory Calibration".
3 Follow the calibration instructions in the Ampler Bike App.
DANGER
During factory calibration, the motor starts by itself and the rear wheel begins to spin. It is important that the rear
wheel is lifted during the whole procedure to avoid damage or injury.
To Next Page
Loading...
