AMX NetLinx NI-3101-SIG User Manual

Programming
145
NI-3101-SIG Signature Series NetLinx Integrated Controller
Configuration Port Commands (Cont.)
Command Description
SET DATE Prompts you to enter the new date for the Master.
When the date is set on the Master, the new date will be reflected on all
devices in the system that have clocks (i.e. touch panels). By the same
token, if you set the date on any system device, the new date will be
reflected on the system’s Master, and on all connected devices.
This will not update clocks on devices connected to another Master (in
Master-to-Master systems).
Example:
>SET DATE
Enter Date: (mm/dd//yyyy) ->
SET DNS <D:P:S> Prompts you to enter a Domain Name, DNS IP #1, DNS IP #2, and DNS
IP #3. Then, enter Y (yes) to approve/store the information in the Master.
Entering N (no) cancels the operation.
Example:
>SET DNS [0:1:0]
-- Enter New Values or just hit Enter to keep current settings --
Enter Domain Suffix: amx.com
Enter DNS Entry 1 : 192.168.20.5
Enter DNS Entry 2 : 12.18.110.8
Enter DNS Entry 3 : 12.18.110.7
You have entered: Domain Name: amx.com
DNS Entry 1: 192.168.20.5
DNS Entry 2: 12.18.110.8
DNS Entry 3: 12.18.110.7
Is this correct? Type Y or N and Enter -> Y
Settings written. Device must be rebooted to enable new settings
SET DUET MEMORY Set the amount of memory allocated for Duet Java pool. This is the cur-
rent Java memory heap size as measured in Megabytes. This
feature is used so that if a NetLinx program requires a certain size of
memory be allotted for its currently used Duet Modules, it can be reserved
on the target Master.
Valid values are 1 - 16 for 32 MB systems and 1 - 48 for a 64 MB
system. This setting does not take effect until the next reboot.
Note: If you are trying to accomplish this setting of the Duet Memory size
via a NetLinx program, the program command
"DUET_MEM_SIZE_SET(int)" should call REBOOT() following a set.
SET ETHERNET MODE <CMD> This command sets the current ethernet configuration settings -
auto OR speed = 10 | 100, duplex = full | half
Example:
set ethernet mode auto
set ethernet mode speed=100 duplex=full
Note: See GET ETHERNET MODE.
SET FTP PORT Enables/Disables the IP port listened to for FTP connections.
Example:
>SET FTP PORT
FTP is enabled
Do you want to enable (e) or disable (d) FTP (enter e or d) :
FTP enabled, reboot the master for the change to take affect.

AMX NetLinx NI-3101-SIG Specifications

General

Brand	AMX
Model	NetLinx NI-3101-SIG
Category	Controller
Language	English