AMX NI-700

WebConsole - System Options
50
NetLinx Integrated Controllers (Firmware v4)- WebConsole & Programming Guide
The device will appear in the Diagnostics Options window, in the next available column (to the right of the last device added
- see FIG. 54).
NOTE: You can monitor diagnostics for up to eight System Devices in this page.
Diagnostics Options Definitions
The following table describes each of diagnostics options that can be enabled via the Edit Options window:
Disabling all Diagnostic Options For a Device
There are two ways to disable all diagnostics for a device:
In the Edit Options window, select Delete to remove the device from the Diagnostics Options page and disable all
diagnostics.
In the Edit Options window, deselect all selected diagnostics options and click Update. This disables all diagnostics for this
device, but leaves the device on the Diagnostics Options page.
FIG. 54
Edit Options window indicating four devices with Diagnostics enabled
Diagnostic Options
Diagnostic Option Description
All Notifications: Enables every notification field.
System
•Number
•Device
•Port:
Use these fields to enter a Device:Port:System (D:P:S) combination for the device for which you want to enable
notifications. A value of 0 for any option gives you all of the systems, devices, or ports. This dialog also allows
you to store/recall presets.
Messages
• Online/Offline Generates a message when there is a change in the target device’s online/offline status.
• Configuration Generates a message when there is a change in the target device’s configuration.
• Status Generates a message when there is a change in the target device’s status.
Channel Changes
• Input Generates a message when there is an input channel change (i.e. Push/Release) in the target device.
• Output Generates a message when there is an output channel change (i.e. CHON/CHOFF) in the target device.
• Feedback Generates a message when there is a feedback channel change in the target device.
Device Options
• Level Changes From Generates a message when there is a level channel change from the target device.
• Level Changes To Generates a message when there is a level channel change to the target device.
• Strings To Generates a message when there is a string sent to the target device.
• Strings From Generates a message when there is a string from the target device.
• Commands To Generates a message when there is a command to the target device.
• Commands From Generates a message when there is a command from the target device.
• Custom Events From Generates a message there is a custom event occurring from the target device.