NetLinx Programming
85
NetLinx Integrated Controllers (Firmware v4)- WebConsole & Programming Guide
I/O SEND_COMMANDs (Cont.)
Command Description
SET INPUT Set the input channel's active state. An active state can be high (logic high) or low (logic low or contact closure). Channel
changes, Pushes, and Releases generate reports based on their active state. Setting an input to ACTIVE HIGH will disable
the ability to use that channel as an output.
Syntax:
SEND_COMMAND <DEV>,"'SET INPUT <channel> <state>'"
Variable:
channel = Input channel 1 - 8.
state = Active state HIGH or LOW (default).
Example:
SEND_COMMAND IO,"'SET INPUT 1 HIGH'"
Sets the I/O channel to detect a high state change, and disables output on the channel.
To Next Page
Loading...
