AMX NXD-1000Vi - Ppof; Ppog; Ppon; Page

Programming
138
NXD-1000Vi 10" Modero® Wall/Flush Mount Touch Panel with Intercom
Page Commands (Cont.)
PPOF Deactivate a specific popup page on either a specified page or the current page.
• If the page name is empty, the current page is used (see example 2 below).
• If the popup page is part of a group, the whole group is deactivated.
• This command works in the same way as the ’Hide Popup’ command in TPDesign4.
Syntax:
"'PPOF-<popup page name>;<page name>'"
Variables:
popup page name = 1 - 50 ASCII characters. Name of the popup page.
page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
Example:
SEND_COMMAND Panel,"'PPOF-Popup1;Main'"
Deactivates the popup page ’Popup1’ on the Main page.
Example 2:
SEND_COMMAND Panel,"'PPOF-Popup1'"
Deactivates the popup page ’Popup1’ on the current page.
PPOG Toggle a specific popup page on either a specified page or the current page.
• Toggling refers to the activating/deactivating (On/Off) of a popup page.
• If the page name is empty, the current page is used (see example 2 below).
• This command works in the same way as the ’Toggle Popup’ command in TPDesign4.
Syntax:
"'PPOG-<popup page name>;<page name>'"
Variables:
popup page name = 1 - 50 ASCII characters. Name of the popup page.
page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
Example:
SEND_COMMAND Panel,"'PPOG-Popup1;Main'"
Toggles the popup page ’Popup1’ on the Main page from one state to another (On/Off).
Example 2:
SEND_COMMAND Panel,"'PPOG-Popup1'"
Toggles the popup page ’Popup1’ on the current page from one state to another (On/Off).
PPON Activate a specific popup page to launch on either a specified page or the current page.
• If the page name is empty, the current page is used (see example 2).
• If the popup page is already On, do not re-draw it.
• This command works in the same way as the ’Show Popup’ command in TPDesign4.
Syntax:
"'PPON-<popup page name>;<page name>'"
Variables:
popup page name = 1 - 50 ASCII characters. Name of the popup page.
page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
Example:
SEND_COMMAND Panel,"'PPON-Popup1; Main'"
Activates the popup page ’Popup1’ on the Main page.
Example 2:
SEND_COMMAND Panel,"'PPON-Popup1'"
Activates the popup page ’Popup1’ on the current page.