Configuring Communication
40
NXD-1000Vi 10" Modero® Wall/Flush Mount Touch Panel with Intercom
Enter a unique Device Number assignment for the panel, and press Done to return to the Protected
Setup page. The Device Number range is 1 - 32000, the default is 10001.
2. Press Reboot to reboot the panel, and apply the new Device Number.
Wireless Settings Page - Wireless Access Overview
Hot Swapping
Hot swapping is not an issue on these panels as the card is installed within the unit and cannot be removed
without first removing the housing.
In the case of DHCP, there must be a DHCP server accessible before the fields are populated.
Before selecting Ethernet as the Master Connection Type you must setup the parameters of the wireless card.
The Wireless Access Point communication parameters must match those of the pre-installed wireless CF
card inside the panel.
The panels allow users to connect to a wireless network through their use of the pre-installed AMX 802.11g
wireless interface card to communicate with a Wireless Access Point (WAP) such as the
NXA-WAP200G). The WAP communication parameters must match those of the pre-installed wireless
interface card installed within the panel. This internal card transmits data wirelessly using the 802.11x signals
at 2.4 GHz. For a more detailed explanation of the new security and encryption technology, refer to the section
of the document entitled: Appendix B - Wireless Technology section on page 1.
For more information on utilizing the AMX Certificate Upload Utility in conjunction with the EAP security,
refer to the section of the document entitled: Appendix B - Wireless Technology section on page 1.
Configuring a Wireless Network Access
When working with a wireless card, the first step is to configure wireless communication parameters within
the Wireless Settings page. This page only configures the card to communicate to a target WAP (such as the
NXA-WAP200G), it is still necessary to tell the panel which Master it should be communicating with.
This "pointing to a Master" is done via the System Settings page where you configure the IP Address, System
Number and Username/Password information assigned to the target Master.
Step 1: Configure the Panel’s Wireless IP Settings
The first step to successfully setting up your internal wireless card is to configure the IP Settings section on the
Wireless Settings page. The section configures the communication parameters from the panel to the web.
FIG. 33 Protected Setup page
If the SSID (Network Name) and WEP fields have not previously been configured, the
Wireless Settings page will not work until the panel is rebooted.
To Next Page
Loading...
