AMX NXD-1000Vi - Installation; Overview; Installing the Internal Components; Installing the No-Button Trim Ring

Installation
23
NXD-1000Vi 10" Modero® Wall/Flush Mount Touch Panel with Intercom
Installation
Overview
NXD panels are installed into either a pre-wall surface (using a CB-TP10 conduit/wallbox) or a solid surface
(using either solid surface or drywall screws).
Installing the Internal Components
Installation of the internal components such as the upgraded Compact Flash and the NXA-WC80211B/CF
Wireless card are described in detail within the following sections:
NXA-WC80211GCF 802.11g Wireless Card (FG2255-07) section on page 12
NXA-CFSP Compact Flash (FG2116-7x) section on page 17
Installing the No-Button Trim Ring
The NXD-1000Vi panel is shipped from AMX with a default Button Trim Ring already installed. The unit is
also shipped with an included Trim Ring containing no button openings (a No-Button Trim Ring) that allows
you, if desired, to change the default configuration of the NXD panel Faceplate to that with no-button
openings. In order to install this included No-Button Trim Ring, you must first remove the factory-installed
default Button Trim Ring, the two small buttons, and associated two clear light pipes.
1. The Faceplate is secured to the panel with plastic latches. To remove the Faceplate, simply pull it away
from the panel by gently tugging it outwards until the entire Faceplate comes away from the panel.
2. Turn the Faceplate over to expose the inside surface and view the Trim Ring latches (FIG. 15).
3. In a single motion, press down and then outwards on the three Trim Ring latches located along the top of
the internal surface of the Faceplate to begin removing the Button Trim Ring. Removing the Internal
Faceplate from the panel exposes the pushbuttons and light pipes along the inside of the Internal
Faceplate.
4. Gently tug along the edges of the Button Trim Ring and work your way around the edges to remove it
from the Faceplate (FIG. 15).
It is recommended that if you are planning on upgrading your panel components
(flash and wireless), you do so before beginning any panel installations.
FIG. 15 Removing the default Button Trim Ring
Default Button Trim Ring
Trim
(with button openings)
B
Faceplate
NXD-1000Vi Panel/enclosure
Ring
Latches
Button latch
Light Pipe latch
(black)
Button and Light Pipe removal
(showing the inside surface of Faceplate)
(outside surface shown)