AMX NXD-1000Vi - Automatically Set SSID; Manually Set SSID

Configuring Communication
46
NXD-1000Vi 10" Modero® Wall/Flush Mount Touch Panel with Intercom
Automatically set SSID
In the Protected Setup page:
1. Select Wireless Settings.
2. Press the Site Survey button.
3. Select a WEP secured WAP from within the Site Survey page, and press the Connect button.
4. Write down the SSID name, Current Key string value, and panel MAC Address information so you can
later enter it into the appropriate WAP dialog fields in order to "sync-up" the secure connection. These
values must be identically reproduced on the target WAP.
Manually set SSID
In the Protected Setup page:
1. Select Wireless Settings.
2. Locate the Wireless Security section (FIG. 40).
3. Press the Static WEP button to open the Static WEP Settings dialog (FIG. 41).
4. Press the SSID field and from the Network Name (SSID) keyboard, enter the SSID name you are using on
your target Wireless Access Point (case sensitive), and press Done when finished.
FIG. 39 Site Survey of available WAPs (Secured WAP shown selected)
FIG. 40 Wireless Settings page
Select a target
WAP with the
desired level of
security
Connecting to the
WAP begins the
communication
802.11g wireless card
You must first take down the SSID name, Current Key string value, and panel MAC
Address information so you can later enter it into the appropriate WAP dialog fields in
order to "sync-up" the secure connection. These values must be identically
reproduced on the target WAP.