AMX NXD-1000Vi - Intercom Commands; Ice; ICM; ICM-Mutemic

Programming
184
NXD-1000Vi 10" Modero® Wall/Flush Mount Touch Panel with Intercom
For instance, http://www.amx.com/img.asp?device=$DV
would become
http://www.amx.com/img.asp?device=10001.
Intercom Commands
Escape Sequences (Cont.)
Sequence Panel Information
$LP Level port
$BX X Resolution of Current button
$BY Y Resolution of Current button
$BN Name of Button
Intercom Commands
^ICE Ends an intercom call.
Syntax:
"'^ICE'"
Example:
SEND_COMMAND Panel,"'^ICE'"
Ends a call.
^ICM Modifies an intercom call.
For backwards compatibility, both ^ICM-TALK and ^ICM-LISTEN are supported; however,
the TALK and LISTEN subcommands are ignored.
The microphone and/or speaker are activated based on the initial mode value of the
intercom start command and the audio data packet flow is started upon receipt of this
command by the panel.
Syntax:
SEND_COMMAND <DEV>,"’^ICM-TALK’"
Variables:
None
Example:
SEND_COMMAND TP1,"’^ICM-TALK’"
^ICM-MUTEMIC Set the state of the microphone on a panel to muted (1) or unmuted (0).
At the start of each call the microphone starts out unmuted.
Syntax:
"'^ICM-MUTEMIC,<state>'"
Variables:
0 - unmuted
1 - muted
Example:
SEND_COMMAND Panel, "'^ICM-MUTEMIC,1'"
Sets the microphone to muted.