Safety instructions qTOWER
3
touch/qTOWER
3
G touch
10
be observed and adhered to. The operator must ascertain the latest version of these
regulations.
The operating and service personnel must have access to the manual at any time!
Observe the following:
The device must only be commissioned, operated and serviced by trained personnel
instructed in technical safety.
The operation or servicing of the device by minors or individuals under the influ-
ence of alcohol, drugs or medication is not permitted.
It must be ensured that only authorized personnel works at the device. The operat-
ing personnel must be familiar with the dangers arising from samples and excipi-
ents. Suitable personal protection equipment must be worn.
Prior to pauses or at the end of the work appropriate skin cleaning and protection
measures must be carried out.
Eating, drinking and smoking at the installation location of the device is prohibited!
The device must be handled with the appropriate care and kept clean in accordance
with laboratory standards to prevent contamination of the device (e.g. on the heat-
able lid). Observance of these laboratory rules reduces the risk of being contami-
nated with potentially infectious material and the risk of cross-contamination of
the samples. Wear protective gloves and/or take other safety measures if there is a
chance that your skin may come into contact with infectious material when han-
dling the device.
The operator must decontaminate the device if the housing or the sample block
were contaminated with hazardous substances. For suitable disinfection agents
and procedures see "Disinfecting the device" p. 27. Other disinfection agents that
are not included in the list shall only be used after consultation with Analytik Jena.
2.5 Safety instructions, transport and installation
Observe the following:
Only transport the device in its original packaging and with the transport lock in
place! Make sure that the device is empty and no sample vessels are in the sample
block.
Please verify that the delivery is complete on receipt of the qTOWER³ touch and
check for possible transport damage. If the delivery is incomplete or the device was
damaged during transport, please contact Analytik Jena AG.
To prevent health damage the following must be observed when moving the device
in the laboratory (lifting and carrying):
To Next Page
Loading...
