qTOWER
3
touch/qTOWER
3
G touch Safety instructions
9
2.2 Safety symbols on the qTOWER³ touch
The qTOWER³ touch is fitted with safety symbols, the content of which must always be
observed. Damaged or missing safety symbols can cause incorrect actions leading to
personal injury or material damage! The safety symbols must not be removed! Dam-
aged safety symbols must be replaced without delay!
The following safety symbols are attached to the qTOWER³ touch and accessories:
Warning against a
hazard location
Warning against hot
surface
Before opening the device always
disconnect the mains plug
The following notice sign is attached to the rear of the qTOWER
3
touch:
2.3 Technical condition
The qTOWER³ touch corresponds in its design and construction to the current state of
the art technology. Unauthorized modifications or changes, especially such that affect
the safety of the staff and the environment, are generally not allowed.
Observe the following:
Any manipulation of the safety equipment is prohibited! In case of an accident
manipulations of the safety equipment will be interpreted as deliberate!
The operator must only operate the device in a sound and operationally safe condi-
tion. The technical condition must always comply with the legal requirements and
regulations.
Prior to every use the device must be checked for damage and sound condition.
Any changes in the device affecting its safety must be reported by the operating
personnel to the operator without delay.
2.4 Requirements for the operating personnel
The qTOWER³ touch must only be operated by qualified specialist personnel instructed
in the use of the device. The instructions also include imparting the contents of this
manual.
In addition to the safety at work instructions in this manual the generally applicable
safety and accident prevention regulations of the respective country of operation must
To Next Page
Loading...
