version 2.0 rev 18 Feb 2021
64
4.2.2 CS-mount Adaptor
The CS-mount adaptor can be adjusted as follows:
1. Loosen the 2 locking screws located in the front face of the adaptor if required using supplied 1.5
mm Allen key.
Figure 41: CS-mount adaptor
2. Manually screw the CS-mount into position until the desired focus is achieved. It must not be
screwed the entire way into the faceplate.
3. Lock the CS-mount into position using the 2 locking screws and 1.5 mm Allen key. NOTE:
Maximum torque applied must not exceed: 0.6 Nm
4.2.3 F-mount Adaptor
The F-mount should be screwed into the camera faceplate by hand.
Figure 42: F-mount adaptor
1. Manually screw the F-mount adaptor until the desired focal position is achieved.
2. Manually tighten the collar down to the camera faceplate to lock the mount in position.
Locking Collar
CS-mount locking
screw locations
To Next Page
Loading...