Copyright by Servizio Clienti ANGELO PO Spa
70
INSTALLATION/WARRANTY REPORT
Date of Installation: …....\........\........
Customer……………………………………………………………………………………………...
Address:………………………………………………………………………………………………T
own/City…………………………………....… Post Code …………… Nation…….................
Telephone:…………………………………………. Fax: ………………………………………...
Invoice n°: …………………Model:……………… Serial Number: …..……………………
CONNECTION DATA
Electric power supply
Voltage: V Frequency: 60Hz
Water connection
Pressure: psi
(facultative)
Type of flue (cf. chap.7 instruction book)
□
A direct discharge under suction hood.
□
A direct discharge under suction hood with fumes evacuation fittings kit.
Type of Gas and Supply Pressure (cf. chap. 7 instruction book)
Note: the appliance is inspected in the factory and set-up for power supply with G20. If used with other gas, replace the
nozzle.
X TYPE OF GAS NOZZLE
REPLACED
TYPE OF GAS
SET
PRESSURE
MEASURED
Methane – P = 3,5-10,5 inch water column
Propane – P = 8-13 inch water column
INSPECTION
System Sealing Check (cf. chap. 7 instruction book)
□
Performed
Analysis of Combustion Products (cf. chap. 7 instruction book)
Note: Activate the fumes control procedure from the control panel. The analysis of the combustion products must be
carried out by an authorised technician. If the values of CO measured exceed the max limit indicated contact the after-
sales centre.
PHASE CO2 (%) CO (ppm)
Phase 1 – minimum cold
CO max: 300 ppm
Phase 2 – maximum
CO max: 300 ppm
Phase 3 – minimum hot
CO max: 300 ppm
Instrument Used (mark and model):…………………………………………………………………
This form, relative to the appliance indicated above, filled-in completely must be sent to Angelo Po SpA within
in order to activate the warranty
Certification: the under-signed, in quality of technician of an Angelo Po authorised after-sales centre, certifies
that all of the items on this form have been filled-in correctly and that the unit is installed correctly.
Installer Technician:………………………… AAC:…………………… Signature……………………..
To Next Page
Loading...
