Angelo Po FX201E2 - Washing Alarms Table

Copyright by Servizio Clienti ANGELO PO Spa
85
5.4. Washing alarms table
Washing cycle control alarms table
Alarm
code
Problem Solution
1
E21
The washing cycle has been
interrupted because the float didn’t
switch during the detergent load
phase.
Check the pipe position and the level of cleaner in the
tank; top up if necessary and restart the washing cycle.
Carry out the CLEAN TEST
2
E22
The washing cycle has been
interrupted because the float didn’t
switch during the sanitizer load
phase.
Check the pipe position and the level of cleaner in the
tank; top up if necessary and restart the washing cycle.
Carry out the CLEAN TEST
3
E24
The washing cycle has been
interrupted because the float didn’t
switch during the tank unload
phase.
Possible obstruction in the oven drain. Carry out the
CLEAN TEST
4
E25
Circuit loading incomplete Carry out the CLEAN TEST
5
E26
The washing cycle has been
interrupted during the rinsing stage,
caused by “missing water”
Carry out the CLEAN TEST